Our deed phrases can vary slightly by client. It would be helpful if there was a way to create, edit, and access multiple deed phrase catalogs to more easily switch between client preferences.

I needed to update one point control but I had no idea where I could find the line (plan element) that was used in the point control. The point I could find in the template or by hoving the mouse over the corridor, but the line (plan element) that...

Instead of a one time thing, create and save the comparison set in a toolbar table. If I want to run again I just need to hit a refresh button for the specifc set. When developing a project, keeping track of cut and fill volumes between design and...

Given that ORD is capable of recognising when it is creating a circular relationship reference, it would be very useful to have something like a geometry relationships "tree" we can view to understand the links between elements which would immense...

After the corridor is created, it is possible to see the final contours. However, the contour elevation labels are not shown unless a proposed surface is created. Why is that so? I believe it would be beneficial to toggle on/off contour elevation ...

To have to go to the Back Stage and select Settings ==> File ==> Design File Settings ==> Civil Formatting ==> Degree of Curve Method to change from an Arc Defined Curve to Chord Defined Curve is not a good workflow. In our State we ca...

Currently in the XSection viewer in OpenRoads Designer if you have a corridor or linear template that touches our butts up against another corridor you can't place temporary dimension lines on those components to make measurements if the linear or...

It's a little cumbersome to keep going back and forth between models when developing annotation groups. An alternative could be to be able to select the geometry that is shown as the example when in the annotation group manager.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...

The manage annotations dialog that is used to create Annotation Definitions automatically saves any changes made. If the dialog is closed then all of the changes are saved even if there was not an intent to save them. Please add a save button or a...