The main line consists primarily of CIP variable XS simple box girders. We are struggling with the limitations of the Bridge Wizard and hope to see these pain points addressed in the next update. Pier/Substructure: The Bridge Wizard does not suppo...

Currently, when multiple trucks (e.g., HL93 and a Permit truck) are selected in the Auto-Generate Live Load tool, the software identifies the heaviest vehicle and applies it to every loaded lane. I am requesting an update that allows the software ...

Add OpenRoads Designer Civil functions to Python integration allowing development of Python applications that can access/call the Civil Design processes within OpenRoads

In recent versions of OBM, the ability to add or remove SupportLines was added. While this is helpful in some cases, it would be more helpful to have the ability to change which SupportLines a given Deck or Beam Layout belong to. That way if the S...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

In the ‘Code Checker Results’, the program summarizes for each girder all the critical load combinations, AASHTO code and controlling performance ratio. As in some diaphragm locations, the program is stating the girder is controlled by fatigue and...

I agree that the excess reinforcement factors would be different for each POI and load case. That is one reason most engineers conservatively ignore that factor. A simple or temporary solution is to set that factor equal to 1. I believe that AASHT...

From the user: "I have a straight steel bridge no skew and it is classifying cross-frames as primary members. Is there away to set cross-frames as secondary member for kL/r check?" This happens because All elements are only set as primary, without...

When annotating elements using an affix (prefix or suffix) tied to a Text Favorite, OpenRoads currently annotates the affix even if the Text Favorite evaluates to a blank or null value. This results in: Stray symbols, separators, or units (e.g.,...

Currently, the only way to update Annotation is to update ALL or one drawing model at a time. It would be very helpful to be able to select a station range to remove and then update in one action.