Make Cross Section to Surface tool available on newer versions of OpenRoads Designer. This tool was available on InRoads.

In recent versions of OBM, the ability to add or remove SupportLines was added. While this is helpful in some cases, it would be more helpful to have the ability to change which SupportLines a given Deck or Beam Layout belong to. That way if the S...

Having the ability to quickly check both existing and design crossfall/superelevation would increase efficiency within the program as there would be no requirement to run a template and report to evaluate existing cross slopes

I know parametric constraints can be exported but if a corridor becomes corrupt then being able to rebuild it from scratch easily would be useful. Similar to an input file in MX

I'd like a tool that synchronizes all template drops in all corridors in a file, right now they have to each be manually selected in the explorer or on screen.

It would be helpful to use quick temporary dimensions in the dynamic cross section viewer. You could potentially use annotation groups that are set up for the cross-section sheets and quickly toggle them on and off, labeling the important features...

when a single-station edit to a cross section is made, it is disassociated to the baseline alignment. Therefore, if the baseline horizontal or vertical alignment is edited after this, the single station edit does not dynamically update to the new ...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

NYSDOT is utilizing trenches on all of their utility and drainage pipes. They have a report they require that quantifies the components within the trench corridor per outgoing pipe from a node. If there was a way to generate an Item Type on the pi...

In the previous Bentley software our DOT used, the software was able to connect the cut and fill lines when transitioning from cut and fill between template drops. Currently the only way that is possible is to have a feature name override on the c...