Existing cant annotation is often, if not always, required on profile drawing. Actually we must project rails onto the profile, create aliases, to extract level differences between existing rails whereas the information is fully available from reg...

Catch basins have the following flow types that can be added: additional subsurface flow (cfs), known flow (cfs), additional carryover flow (cfs), external CA (acres), and external Tc (min). Manholes only have the option of known flow. Known flows...

Allow a checkbox to choose to overwrite or replace existing saved views when re-processing a set of named boundaries for output to sheets. This will help to maintain order in the files and avoid excess unused items. If not creating another 'versio...

The class of a pipe is primarily selected by the depth of cover over a pipe. Sometimes vehicle loads or construction loads have an influence on the class selection

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...

This would be good for 3D modelling of any item that needs to slope the same as the design surface such as guard fence terminals. This is available within the Drainage and Utilities, but when using this it loads a lot of other information into the...

OpenBridge does not seem to have a dedicated functionality for drainage system. I have seen solution in OpenBuildings, it looks quite decent. Just to clarify, when I refer to a drainage system, I mean elements like drip pipes, scuppers, vertical p...

It's a little cumbersome to keep going back and forth between models when developing annotation groups. An alternative could be to be able to select the geometry that is shown as the example when in the annotation group manager.

Plese copy tool "Place cell/ block" from Bentley Rail Track SS2 to Open Rail to have possibility annotate cant on cross sections. Many Thanks in advance.

A tool that makes it possible to annotate the distance between two points along an alignment or between points on two different alignments, but parallel to one alignment is my wish. It would be useful, so you don´t need to annotate or write down t...