Requirement is to annotate horizontal length of straight on profile (station end - station start). It is available in frame annotation but not along linear so annotations don't match. Only the slope length can be annotated along the linear

It would be helpful to use quick temporary dimensions in the dynamic cross section viewer. You could potentially use annotation groups that are set up for the cross-section sheets and quickly toggle them on and off, labeling the important features...

when a single-station edit to a cross section is made, it is disassociated to the baseline alignment. Therefore, if the baseline horizontal or vertical alignment is edited after this, the single station edit does not dynamically update to the new ...

In LEAP substructure modules, it would be helpful to be able to add loads to the footing, other than vertical earth. Sometimes there are miscellaneous components of the pier/abutment where the weight needs to be considered, but are not a part of t...

Since the 8th edition of AASHTO there has been more detail given on the use of Strut and Tie Modeling for the design of D-Regions in Concrete structures (AASHTO 8th & 9th Editions Section 5.8.2 and subsequent sections). In recent years there h...

There are currently some things needed to be added to the Corridor Object dialog to help communicate design intent a bit better to users (especially with Parametric Constraints): The lack of information as to the rules linked to Parametric Constra...

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...

XSLT 3.0 introduces several new features and improvements that can enhance the development process, increase efficiency, and provide better results. Performance Improvements: XSLT 3.0 includes optimizations that can significantly improve the perfo...

U.S. surveyors traditionally work in Northing & Easting, in that order. When working with Microstation V8i, AND with Inroads loaded, the user could perform precision drafting by using the “NE= “ key-in to enter the exact northing/easting coord...

Add the ability to add a Gap in the profile after an equation so the major stations still align with the major grids in the profile drawing model beyond the equation. The functionality would be similar to GEOPAK's Gap/No Gap option when plotting a...