Currently, the cyan line for tracking dynamic cross-sections always appears in plan and 3D views. However, in profile view, it only appears if you are in the profile DGN and the dynamic cross-section view has been set by "Select alignment/left-rig...

It would be useful if existing and proposed track intervals (6fts) could be displayed automatically in the tabulated data of a profile for a drawing.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.

The calculation executive summary and calculation detailed summary would be improved by adding a time stamp near the date and file name at the bottom of the reports' pages. It would be helpful to be able to add a note to the reports describing tha...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?

Construction stage analysis for precast beams and cast-in slabs is important for composite deck design.

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...

Currently when only one rail alignment can be selected to output a horizontal report. Would be great if the ability to select multiple alignments and output a horizontal report at the same time. Reason: Currently have projects which contain multip...