Need Support? Let’s guide you to the right answer or agent.

OpenRoads Ideas Portal

ADD A NEW IDEA

All ideas

Showing 91

Need a Text Favorite for Arc Chord Bearing

IDOT's Right-of-Way annotation requires the Chord Bearing as part of the annotation. When setting up annotations for the Civil Labeler, we found that an option for the chord bearing is currently not available as a Text Favorite when selecting Civi...
8 days ago in Annotation / OpenRoads Designer 1 Already exists

Profile from Top Mesh

We have the ability to create multiple profiles from multiple surfaces at the same time, but there are occasions where I only need to define a single profile line based on multiple surfaces. It would be handy if there was an option to create a pro...
about 1 month ago in Geometry 8 Already exists

Clip Conduits (pipes) at inside edge of Drainage Structures and Report "True" Horizontal Lengths and Vertical Lengths in the Properties

This is more than useful; this is absolutely required. When laying out Drainage Networks, pipes need to be trimmed at the inside edge of the structures, and the "True" pipe lengths (horizontal & vertical) need to be provided in the properties....
29 days ago in Drainage and Utilities / Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 5 Already exists

Export multiple terrain models as a single XML file

We deliver terrain models for top/bottom surfaces of a roadway. Due to gaps in project data we often have multiple top surfaces and multiple bottom surfaces. It would be nice to export all surfaces as a single XML file similar to alignments.
10 months ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 4 Already exists

Create a rule to set drainage node to (active terrain) when setting elevation reference

Presently when setting reference elevation for the node it lets you set it to the active terrain but does not rule it to the (active terrain). If this were done the inlet tops would automatically adjust as the design terrain changes.
about 2 years ago in Drainage and Utilities 1 Already exists

DU: add drop calculation to node invert depending on lowest conduit wall thickness

Some times, most common with concrete conduits, the node invert needs to have a drop in reference to the lowest pipe to acomodate its wall. This would later be filled to match.For construction and BIM purpose, this difference is important. Special...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 3 Already exists

Add profiles from different horizontals to a rollplot sheet

Would like an easier way to add multiple profiles to a single sheet that belong to different horizontal alignments. Specifically we're looking for a way to quickly place all the drainage profiles (which below to different horizontal alignments) on...
over 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Isopachyts (Delta Terrain) Export to Autocad

In MX Roads days we are exporting Isopachyts band to Autocad but i believe this functionality of exporting to ACAD is not available in ORD
5 months ago in OpenRoads Designer 0 Already exists

Ability to control the cl profile (in a template/corridor) by vector offset method from adjacent corridors on either side.

I would like to control the elevation of my centerline point (point in template) to be controlled by a "vector offset method" by selecting to points (corridor feature) in two corridors that running parallel.
about 2 months ago in Modeling / OpenRoads Designer 5 Already exists

No possibility to set the lower limit height of the profile

When creating profiles using ,,Named Boundary”, I cannot set the lower height limit of the profile. I propose to add in the next part of ORD setting the lower height limit if we want to make one drawing sheet from profile. This would help with the...
about 2 months ago in Drawing Production / OpenRail Designer 1 Already exists