I noticed that template ranges can overlap and there is no obvious indication that this is occurring. Ideally over lapping station ranges should highlight in red to draw attention to it.

This improvement would use graphic symbols (construction elements) to represent constraint relationships in plan view. For horizontal elements that are snapped, there are the snap glyphs that show that there is a relationship, but there is not a w...

Currently, in order to create en equilateral turnout, one needs to recreate one of the branches (with exact geometry) and then add the branch part. This process has a lot of inconsistencies and sometimes results in unexpected geometries ( transiti...

This would be useful for agencies with strict installation procedures that prevent the installation of exe files.

Add ability to copy points, components and sets of components

Constructing horizontal or vertical geometry tangents with endpoint snap rule enabled creates a one-way relationship only allows editing from one direction. In contrast, MicroStation constraints allow for two way editing. For example the coinciden...

When using Set Feature Definition (FD) or change FD in Properties dialog, to assign / change a FD to a Complex Geometry, such process only affects the Complex Element entity itself, i.e. FDs of all geometry elements which the complex element is ma...

Currently you can use "analyze point" to see where you are at in the plan view while in a profile. I want the location line in plan to show up all the time while I am in a profile so I know where I am at.

Option to keep siding alignment start station in synch with mainline alignment as shown in the attached video

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;