I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...

Currently, Drawing annotation for Cross Section is only available for Ground Z and (design) Z. If there are multiple stratum and terrain models, no direct option to annotate the height/offset difference from design to other stratum, or stratum (te...

It would be very helpful if we could reflect a template while assigning it to a template drop. Templates currently can only be placed in the direction they were created, from template origin "out". This requires a duplication of templates, as sepa...

When creating a cut/fill End Area Volumes table on cross sections, the annotation does not work for surface templates. If there is no corridor in the cross section, it will not even place an EAV Table. The cut/fill EAV tool works and displays the ...

This would allow annotation on Geometry to export to KMZ files. Currently you have to drop status on all text annotation on geometry to be able to see it in a KMZ file.

It would be great if ORD had the capability to connect a channel directly to an On Grade Inlet to be able to calculate spread and bypass at the inlet. Currently the workaround is to connect the channel to a Generic Outfall at the edge of the inlet...

Need the ability to create a Text Favorite for the Description Field of an Event Point.

For detail grade areas it would be nice to place points in plan view and snap lines to those points. The lines would have annotation groups assigned to them to label the slope and distance between the points. Grades could then easily be tweaked by...

This would be useful as we currently manage multiple signage replacement projects per year (10-15) that involve the layout of hundreds of signs in SignCAD. This represents a large portion of the labor hours in the creation of engineering plans for...

Geometry/Lines requires you to enter the bearing value as S45d30'30"E which is way too many key strokes and unproductive. Geometry Builder allows us to enter the same bearing using the quadrant method (245.3030) which is much faster/easier and ali...