If you have Element Templates (ET) separate from your Feature Definitions / Feature Symbologies, ORD will make a local copy of an ET if it is used in a Feature Symbology. If that ET is updated, you must delete the ET and copy in the updated versio...

It would be good to add to the OBM library, for example standard abutments types used in the UK that are not integral and need an abutment gallery to align with the CIRIA C543 Bridge detailing guide.

In InRoads there was an option to import data as depths instead of elevations. This is common practice for hydrographic data, as many dedicated programs have positive elevations being below 0, with elevations above as negatives. ASCII files can be...

Currently "Create 3D by Drape" tool does not support point elements/ zero length elements. The modify point and drape element tool also does not work for zero length elements. Kindly add the support for zero length elements in "Create 3D by Drape ...

A formula could be made using existing columns to calculate a value that is atypical or not an option otherwise. I need a pipe full flow velocity check for a design. I can use excel to calculate using full flow capacity and full flow area but if t...

The project is done without any geocoordinates and there is need to shift the overall project datum. currently the option to shift the model vertical elevation/ datum is not available. For Example, the original model done is at el. 16'...but need ...

Currently When importing pulling in pipe networks (both utility and drainage) two things happen 1.) They lose a lot of data. 2.) you can only do it once. Then you have to erase EVERYTHING and do it again. The workflow generally goes like this: So ...

Currently to get a specific vertical alignment on utilities it is quite difficult

When using Geometry Connector to connect turnouts, it is often that we must extend the last arc of the turnout. Because the arc is in the turnout we cannot extend it. Instead, we must add an arc of same radius. It would be nice that in such situat...

So, we have been told that exporting to DXF or DWG will not be implemented. Could we talk about bringing back the CAD export settings from the legacy version. I can open DGN files in several 3rd party software packages but need to turn off block t...