Currently there are values for StationStart and StationEnd, which is dependent on the direction of the line being drawn. I am proposing an additional option to report the beginning and ending of stationing with respect to the alignment (smallest t...

An option to add "geometry lock points" in the geometries with higher priority than the usual rules would be really useful to make the geometry behave as you wish. As an example it could be the center point of a radius so that the radius keeps it ...

In complex geometries it does not seem to be possible to move the center point of a circular curve. When working with different alternatives, it´s common to have two geometries that shares some part of a circular curve with different start or end....

When selecting that option on design file settings or other places like the fields on text favorites. User needs to control the symbology of the divisor between Rise and Run. it seems to be hardcoded to use (:). User needs to change it to other te...

A column on drilled shafts can have different fixity locations for different load cases. Suggest allowing analysis of the same bridge with different fixities rather then needing to create multiple models with varying fixities for simplicity.

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...

The Standard Sign Panel: Equilateral Triangle does not have an option to specify separate radius values for the inside and outside of the panel which is needed for creating signs.

We need better access and configuration for this constant. There is no place to set this constant.

It will be helpful to see where the clipping is coming from. Example if reference file then would be helpful to know what reference file