Constructing horizontal or vertical geometry tangents with endpoint snap rule enabled creates a one-way relationship only allows editing from one direction. In contrast, MicroStation constraints allow for two way editing. For example the coinciden...

I need some additional settings to label the side without a value so that I can annotate my plans as required. The text favorite settings for “OpenRoads Plan Annotation Fields-Point Offset” does have settings to use a suffix to label a “Right” or ...

Create a tool to clip an alignment at any location along the alignment that does not affect or change the stationing or the station equations even if you are clipping the beginning of the alignment.

Add the conduit table options similar to drainage for managing conduit sizes, materials, etc... Right now you have to input a conduit table for each utility type and can't import a table from utility to utility. Just need one set of tables to mana...

It would be useful to be able to turn on-/off single alignments. Perhaps with a checkbox in the "OpenRail Model" section in the explorer, just like the ones in the "Feature definition" section in OpenRail Standards. This could probably be handy wi...

When the bridge needs a long “wingwall”, it break two part – a wingwall which is built with the abutment, and the rest part I call it “Retaining wall”. Is it possibly to make this retaining wall as easy as wingwall? That means like put the wingwal...

Option to keep siding alignment start station in synch with mainline alignment as shown in the attached video

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;

Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...

Ability to add a profile elements of an alignment as an external references when using the Target Aliasing command.