Need Support? Let’s guide you to the right answer or agent.

OpenRoads Ideas Portal

ADD A NEW IDEA

OpenSite Designer

Showing 672

Add the ability to place banks of conduits.

Electrical and Communications conduits are usually placed in banks of multiple conduits of say 12 conduits which may be of different sizes.
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
over 1 year ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Ability to Include Profile when off setting 2D Geometry

It would be much more intuitive and beneficial if there was an option to "include" the profile of a geometry element when using the Offset Tools. Currently, the workflow is to offset the 2D geometry, and then copy the Profile from the reference ge...
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Ability to flip/reverse cross sections around baseline.

Ability to flip/reverse cross sections around baseline. Currently, when you reverse section, it does not hold station 0.
over 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Graphics should be excluded from being made part of a complex alignment

If a grahic, a constuction line for example, is touching an alignment element, it will be included in the alignment when the "automatic" funtion is used in Create Complex Geomtery tool The create complex geomtry tool should only take into account ...
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Civil Labeler - multiple intersection points

I want to create a label that will be placed at the intersection of a corridor line and several drawn pattern lines. However, the Intersection placement method only allows for one selection and one other selection. You can't use a selection set. W...
almost 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Single Offset Partial/Entire Element creates complex elements with the ability to add/remove tapers

One of the factors prohibiting the use of civil geometry in plan production is that it can often feel cumbersome to implement design changes without 'breaking' your previous work. Let's say you have an intersection designed using civil geometry, a...
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Needs ability to set RIM Depression Depth

Needs ability to add RIM Depression Depth with elevation (ground). Currently we can only set the Elevation (RIm) but not any depression value.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

"create new .xml file" or "close .xml file" button in geometry builder

Currently, if you have an existing .xml file open in the geometry builder it remains open until you exit OpenRoads. Simply opening a new drawing does not close the .xml file. Due to the significant amount of time it takes to open and close .dgn's ...
5 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration