Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

Applications

Showing 81

Bevel vertical face of stiffeners/connection plates at web

When the connection plates or stiffeners are placed, they are appearing half-embedded into the web with an equivalent gap on the opposing edge. For it to actually be correct, the plates should be beveled to match the vertical face of the web.
about 1 year ago in OpenBridge Modeler 0 Needs review

ITL Copy Components

Add ability to copy points, components and sets of components
7 months ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Automatically adjust structure Hight to include pipe thickness

it would be more accurate to calculate the structure Height if when a pipe is connected to a structure that the bottom base slab was adjusted to be below the wall of the pipe. this would also make the 3D model look better.

Update turnout library for concept station

Clearly, concept station has a lot of potential as a conceptualization tool. However, just as any other tool at its birth, has issues that needs to be adressed. I noticed that the turnout library for swedish turnouts is outdated: it does not have ...
8 months ago in OpenRail ConceptStation 0 Needs review

ajouter liste déroulante des fields code dans Survey

ajouter liste déroulante des field code dans Survey, dans PowerInroads c'était possible et ça évite d'avoir une liste de code à consulter
3 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Needs review

SUDA - Spread Slope

Make it easier to manage longitudinal spread slope. It's nice to input the slope in the properties per node, but consider making it integrated to the gutters used during bypass flow drawing of gutters.
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Place Template from template library in a drawing

We create typical cross sections as part of our plan set. I've seen guidance from Bentley on how to use different parts of the 3D corridor model to cut cross sections in specific places and then use those cross sections as the typical cross sectio...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Needs review

Hide underground and above ground pipes and equipment

Using OpenSite Designer, is there a way to hide items, i.e. pipe, valves, and equipment, below a surface? These components are on multiple elevations above and below this surface. All components are on the same level, i.e., WATER. Client does not ...
6 months ago in Modeling / OpenSite Designer 2 Needs review

RM Bridge update to use the correct AASHTO reduction factor for reinforced/prestressed concrete based on tensile strain in reinforcing at ultimate limit state.

The current RM bridge ultimate capacity calculations allow for material reduction factors only, which are not used by AASHTO for reinforced and prestressed concrete. AASHTO concrete reduction factors for flexure and P-M capacities are based on the...
7 months ago in OpenBridge Designer 0 Needs review

Model a straight bridge on a curved alignment

The ability to create a straight bridge when the alignment transitions from tangent to a horizontal curve on the bridge. Currently the deck ends are controlled by the bridge skew from a radial line at the end of the deck rather than from the tange...
about 1 year ago in Geometry / OpenBridge Designer / OpenBridge Modeler 0 Needs review