Need Support? Let’s guide you to the right answer or agent.

OpenRoads Ideas Portal

ADD A NEW IDEA

CANT

Showing 15

Support "Apply Mainline Cant Through Turnout" in Create Cant command

This tool works for the branch geometry that is starting with a tunout. While creating the cant it applies the same cant value it read from main track geometry to the start of the turnout geometry. Also tool needs to have an option to change rotat...
about 2 years ago in CANT 0 Future consideration

Folders for Cant Tables

In order to use Cant Tables, a significant number of Cant Tables need to be created. As such, the ability to organize the tables into folders within the DGNLIB is needed.
about 2 years ago in CANT / OpenRail Designer 0 Future consideration

Customisable Track Design Parameters

There is currently no way to view what cant ratios and related cant values the software is applying to the alignment. Nor is there an option to change the maximum and minimum values applied. The software should have an option to amend the followin...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
about 1 year ago in CANT / Geometry / OpenRail Designer 0 Future consideration

Numerical display for applied cant

Recommended that a when using the cross-section tool to view the applied cant along the alignment, the tool displays the cant as numerical value on the cross-section. The number should be generated automatically and displayed next the chainage...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration