Need Support? Let’s guide you to the right answer or agent.

OpenRoads Ideas Portal

ADD A NEW IDEA

OpenBridge Designer

Showing 24

PMM non-linear springs

We would like to ask a PMM non-linear spring for modeling Plastic Hinges for reinforced-concrete Columns. This PMM springs are used for modeling the Moment-Rotation (M-R) behavior for different axial loads (P). The PMM spring should be able to cap...
2 months ago in Analytics / OpenBridge Designer 0 Needs review

provide highlighting or red text for the following note to better stand out when value is non-zero

Enhancement Request to provide highlighting or red text for the following note to better stand out when value is non-zero.
2 months ago in OpenBridge Designer / User Interface 0 Needs review

Fiber Mesh Cross Sectional Analysis

Con sider adding fiber-mesh tools for cross section analysis to RMBRIDGE. This allow the use of different materials in the cross section. This is important in seismic analysis for the definition of the Moment-Curvature properties. This feature is ...
2 months ago in Analytics / OpenBridge Designer 0 Needs review

Include ability to model curtain wall under end bent

Please include ability to model curtain wall under end bent, similar to backwall. This curtain wall is a great tool when working on projects when new fill required to place is not significant enough to just an independent retaining wall but is sig...
6 months ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

RM Bridge update to use the correct AASHTO reduction factor for reinforced/prestressed concrete based on tensile strain in reinforcing at ultimate limit state.

The current RM bridge ultimate capacity calculations allow for material reduction factors only, which are not used by AASHTO for reinforced and prestressed concrete. AASHTO concrete reduction factors for flexure and P-M capacities are based on the...
9 months ago in OpenBridge Designer 0 Needs review

Anisotropic shell elements in RM Bridge

The implementation of FEM shell elements as a supplement to the beams in RM Bridge Enterprise, is a useful tool. Sometimes it will be useful to model the shell elements with different properties in the longitudinal direction compared to the transv...
9 months ago in OpenBridge Designer 0 Needs review

Transverse PT for shell element segmental box girder

Introduction of Transverse PT for shell element segmental box girder.
10 months ago in OpenBridge Designer 0 Needs review

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
11 months ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review

Stepped Footing

Add option for Steeped footing in Leap Concrete - Substructure Module
about 1 year ago in OpenBridge Designer 1 Needs review

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
about 1 year ago in OpenBridge Designer 0 Needs review