Revised Justification for DU Cell Enhancements If Drainage and Utility (DU) cells could incorporate linear and point features, these elements could be utilized as break lines within graphical filters for terrain modeling. Additionally, such featur...

It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...

A new annotation filter setting (Label) was introduced in OpenRoads 2025. This setting works well to place callouts for corridor components, however when drainage/utility features are selected, we run into issues as shown below. The callout does n...

This would dramatically reduce the requirement for a vast number of library cells and feature definitions to be created

PowerInroads used to have a built in calculator/analyzer. It helped us to quickly calculate the drainage pipe information, minimum slope and velocity at full value etc. Currently to get the data, we use Flow Masters and manually calculate each pip...

Trench templates are used on pipes for fill quantities. It would be useful if you could place a trench that would automatically assign parametric constraints based on the size and pipe thickness of the pipes. Also, shapes other than a circle are d...

Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...

A tool to move multiple nodes at the same time is needed in ORD as such tool or functionality was not observed with ORD. This is helpful for situations where the nodes will be offset by a certain distance due to the buildings or other constraints ...

I would like the ability to control the limits of the profile run in profile sheets which would also allow me to control the stationing without having to create a separate alignment and project the drainage run into the separate alignment.

It would be very helpful and much more efficient if there was an option to insert a vertical bend or curve into a drainage link/pipe from the profile run profile view. Basically, adding the exact same tool that is available in plan/horizontal call...